Products

JDH 5.30 Floor expansion joints with flexible insert

MATERIAL

ALUMINIUM

GALVANIZED STEEL

STAINLESS STEEL

NITRILE

 

COLOUR

BLACK, GREY

RAL COLOURS

 

VERSION

FLAT ANGLE

 

 

  • Movement
  • Load
  • Environment
  • Watertight floor expansion joint
  • Designed for car parks, ramps, podiums…
  • For joint gaps from 15 to 35 mm

Waterproof floor expansion joint for car parks, access ramps, esplanades and any other applications without traffic or with traffic of low speed vehicles. It comprises a waterproof interchangeable flexible section able to take up expansion and contraction movements. The 910/PR joint is held by two galvanised steel or stainless steel strips available in different thicknesses.

For indoor and outdoor floor joints with a gap between 15 mm and 35 mm. Suitable for medium heavy traffic of heavy vehicles on pneumatic tyres and intense traffic of light vehicles.

Pre-drilled side strips, 3 m length, galvanised steel or stainless steel. Nitrile insert, roll length of 21 m.


Floor-to-floor type, can also be installed as floor-to-wall type with exposed skirting. Black or gray insert welded using a hot knife to ensure the integrity of the joint. Galvanised steel or stainless steel side strips according to requirements.

Reference
JDH 5.30
Gap (mm)
W
Movements (mm)
Visible width (mm)
S
Total width (mm)
B
Height (mm)
H
Loads
JDH 5.30 15 à 35 ± 15 150 à 180 150 à 180 25 Pedestrians Fork-lift trucks on pneumatic tyres Light vehicles Heavy vehicles
Reference
JDH 5.30
JDH 5.30
Gap (mm)
W
15 à 35
Movements (mm)
± 15
Visible width (mm)
S
150 à 180
Total width (mm)
B
150 à 180
Height (mm)
H
25
Loads
Pedestrians Fork-lift trucks on pneumatic tyres Light vehicles Heavy vehicles

The load-bearing capacity is always indicated for a joint in its initial position. In case of opening movements, the load-bearing capacity significantly reduces and the product will thus be only adapted for a light pedestrian traffic. The indicated load-bearing capacities are based on pneumatic wheels vehicles with a contact surface of 200x200 mm.