Products

JDH 5.32 Floor expansion joints with flexible insert

MATERIAL

ALUMINIUM

GALVANIZED STEEL

STAINLESS STEEL

NITRILE

 

COLOUR

BLACK

RAL COLOURS

 

VERSION

FLAT ANGLE

 

 

  • Movement
  • Load
  • Environment
  • Watertight floor expansion joint
  • Designed for car parks, ramps, podiums…
  • For joint gaps from 50 to 70 mm

Waterproof floor expansion joint for car parks, access ramps, esplanades and any other applications without traffic or with traffic of low speed vehicles. It comprises an interchangeable flexible section able to take up expansion and contraction movements, held by two mill finish aluminium or galvanised steel or stainless steel strips available in different sizes.

For indoor and outdoor floor joints with a gap between 40 mm and 70 mm. Suitable for medium heavy traffic of heavy vehicles on pneumatic tyres and intense traffic of light vehicles.

Pre-drilled side strips, 3 m length, galvanised steel or stainless steel. Nitrile insert, roll length of 16 m.


Floor-to-floor type, and floor-to-wall type with exposed skirting (type E). Black insert. Galvanised steel or stainless steel side strips according to requirements. Insert welded using a hot knife to ensure the integrity of the joint. Special parts on demand (T, X, L...).

Reference
JDH 5.32
Gap (mm)
W
Movements (mm)
Visible width (mm)
S
Total width (mm)
B
Height (mm)
H
Loads
5.32 50 --> 70 +45 / -20 220 220 11 Light vehicles
Reference
JDH 5.32
5.32
Gap (mm)
W
50 --> 70
Movements (mm)
+45 / -20
Visible width (mm)
S
220
Total width (mm)
B
220
Height (mm)
H
11
Loads
Light vehicles

The load-bearing capacity is always indicated for a joint in its initial position. In case of opening movements, the load-bearing capacity significantly reduces and the product will thus be only adapted for a light pedestrian traffic. The indicated load-bearing capacities are based on pneumatic wheels vehicles with a contact surface of 200x200 mm.